Safety precautions

WARNING

● For safety reasons, avoid operating of the cell phone while driving.

● Do not make a phone call while driving. When you have an incoming call, stop the vehicle in a safe location before taking the incoming phone call. When you have to absolutely take a phone call, tell the caller Ill call you back. And then call the caller back after stopping the vehicle in a safe location.

● Part 15 FCC Rules FCC Warning:
Any unauthorized changes of modifications to this equipment would void the users authority to operate this device.

CAUTION

● Do not leave the cell phone in the vehicle. The temperature in the vehicle may become extremely high and cause a malfunction of the cell phone.

● When using the cell phone, be careful not to get it close to the in-vehicle equipment. Getting it too close to the in-vehicle equipment may result in deterioration in tone quality or a poor connecting condition.

● In the frequency band used by this equipment, along with industrial, scientific and medical equipment such as a microwave oven, radio stations (a license is required) to be used by the production line in the factory to identify movable bodies, specific small power radio stations (a license is not required) and amateur radio stations (a license is required) are being operated. (These three types of radio stations are hereinafter referred to as other radio stations.) Before using this equipment, be sure to check to see if other radio stations are being operated in the vicinity. If there is detrimental radio interference from this equipment to other radio stations, move the equipment to another location as soon as possible to avoid radio interference. The frequency band used by this equipment is in the 2.4 GHz zone. The FH-SS modulation is employed as a modulation method. The expected inflicting interference distance is less than 33 ft (10 m). This equipment uses a full band and can avoid a band used by a movable body identification device.

    See also:

    Transmission control system warning
    If the AT OIL TEMP warning light flashes after the engine has started, it may indicate that the transmission control system is not working properly. Contact your nearest SUBARU dealer for servic ...

    Unfastening the rear seatbelts seatbelt
    Push the button on the buckle. Before closing the door, make sure that the belts are retracted properly to avoid catching the belt webbing in the door. ...

    Light control switch
    The light control switch only operates when the key is inserted into the ignition switch. Regardless of the position of the light control switch, the illuminated lights are turned off when the ke ...