Subaru Outback: Channel scan
If you press the “SCAN” button while the radio is in the category search mode,
the radio turns to the category SCAN mode. In the category SCAN mode, the radio
scans only channels in the selected category. If you press the “SCAN” button while
the radio is not in the category search mode, the radio turns to the ALL SCAN mode.
In the ALL SCAN mode, the radio scans all channels.
In both SCAN modes, the radio will stop at the station for 5 seconds while displaying
the channel number, after which scanning will continue until the entire channel
has been scanned from the low end to the high end.
Press the “SCAN” button again to cancel the SCAN mode and to stop on any displayed
channel.
READ NEXT:
How to preset channels
1. Press the “SAT” button to select SAT1, SAT2 and SAT3 reception.
2. Select the desired channel.
3. Press one of the preset buttons for more than 1.5 seconds to store th
Presetting a channel with a preset button allows you to select that channel in
a single operation. Up to six SAT1, SAT2 and SAT3 channels each may be preset.
SEE MORE:
Unrestrained pets can interfere with your driving and distract your attention
from driving. In a collision or sudden stop, unrestrained pets or cages can be thrown
around inside the vehicle and hurt you or your passengers. Besides, the pets can
be hurt under these situations. It is also for th
A: REMOVAL
1) Remove the front wheels.
2) Fully open the front hood.
3) Disconnect the ground cable from battery.
4) Remove the collector cover.
NOTE:
Follow the steps below when removing the collector
cover.
Pull up the two points at the rear (A).
Pull up the two points at the front (B) whil
© 2010-2024 Copyright www.suoutback.com