Subaru Outback (BR): Defrosting or defogging
To direct warm air to the windshield and front door windows:
1. Press the “” button.
2. Set the temperature control dial to the red side.
3. Set the fan speed control dial at the highest speed.
NOTE
When the “” button or “”
button is pressed the air conditioner compressor automatically operates to quickly
defog the windshield. However the indicator on the air conditioner button will not
illuminate. At the same time, the air inlet selection is automatically set to “outside
air” mode.
READ NEXT:
NOTE
● Operate the automatic climate control system when the engine is running.
● The blower fan rotates at a low speed when the engine coolant temperature is
low.
For efficient defog
1) Temperature control button (driver’s side) 2) Dual mode button
3) Airflow mode selection button 4) Fan speed control button 5) Temperature control button (front passenger’s s
FULL AUTO mode operation:
When the “AUTO” button is pressed, the indicator light “FULL AUTO” on the display
illuminates. In this state, fan speed, airflow distribution, air-inlet control,
SEE MORE:
A: INSPECTION
1) Park the vehicle on a level surface.
2) Check the clutch fluid level using the scale on
the outside of the reservoir tank. If the clutch fluid
level is below "MIN", fill the clutch fluid up to "MAX"
level, and make sure that there is no leakage.
MAX. level
MIN. level
Reservoir
Driver’s side
Passenger’s side
To increase the temperature setting, press the “”
side of the temperature control button. To decrease the temperature setting, press
the “” side of the temperature control
button.
Each temperature setting is shown on the display. When the “LO
© 2010-2024 Copyright www.suoutback.com