Subaru Outback (BR): Rear wiper
To turn the rear wiper on, turn the knob on the end of the wiper control lever
upward to the “INT” or “ON” position. To turn the wiper off, return the knob on
the end of the lever to the “OFF” position. With the switch turned to the “INT”
position, the rear wiper will operate intermittently at intervals corresponding
to the vehicle speed.
When you subsequently move the select lever to the “R” position (AT and CVT models)
or the shift lever to the reverse position (MT models), the rear wiper will switch
to continuous operation. When you move the select lever/shift lever from the “R”
(reverse) position to another position, the rear wiper will return to intermittent
operation.
READ NEXT:
To wash the rear window while the rear wiper is operating, turn the knob on the
end of the wiper control lever upward to the “”
position. The washer fluid sprays until you release the knob. To
1) Rear window defogger
2) Outside mirror defogger (if equipped)
3) Windshield wiper deicer (if equipped)
The vehicle is equipped with a rear window defogger. Some models are also equipped
with
Always check that the inside and outside mirrors are properly adjusted before
you start driving.
SEE MORE:
Always block the wheels under both vehicle and trailer when parking. Apply the
parking brake. You should not park on a hill or slope. But if parking on a hill
or slope cannot be avoided, you should take the following steps:
1. Apply the brakes and hold the pedal down.
2. Have someone place whe
General Description
A: SPECIFICATION
B: COMPONENT
1. PARKING BRAKE (REAR DISC BRAKE)
Back plate
Retainer
Lever
Parking brake shoe (Primary)
Parking brake shoe (Secondary)
Strut spring
Strut
Shoe guide plate
Primary return spring
Secondary return spring
Adjusting screw
Adjusting spring
© 2010-2024 Copyright www.suoutback.com