Subaru Outback (BR): Turn signal indicator lights
Subaru Outback (BR) 2010-2015 Owners Manual / Instruments and controls / Warning and indicator lights / Turn signal indicator lights
These lights show the operation of the turn signal or lane change signal.
If the indicator lights do not blink or blink rapidly, the turn signal bulb may be burned out. Replace the bulb as soon as possible. Refer to “Replacing bulbs” F11-48.
READ NEXT:
High beam indicator light
This light shows that the headlights are in the high beam mode.
This indicator light also illuminates when the headlight flasher is operated.
Indicator light for cruise control in Outback (2010-2015)
The indicator light for cruise control becomes illuminated upon turning the ignition switch to the “ON” position and remains lit for around 3 seconds. Activation of this light al
Cruise control set indicator light
The cruise control set indicator light illuminates when the ignition switch is
turned to the “ON” position and turns off after approximately 3 seconds.
This light illuminates when vehicle spe
SEE MORE:
Center Differential Carrier
A: REMOVAL
1) Remove the transmission assembly from the vehicle.
<Ref. to 5AT-37, REMOVAL, Automatic
Transmission Assembly.>
2) Remove the rear vehicle speed sensor, and separate
the extension case from transmission case.
<Ref. to 5AT-65, REMOVAL, Extension Case.>
3) Extract the rear
Body Control System - List of Diagnostic Trouble Code (DTC)
A: LIST
Diagnostic Procedure with Diagnostic Trouble Code (DTC)
A: DTC B1100 INTEG. UNIT SYSTEM ERROR
DTC DETECTING CONDITION:
System error in body integrated unit
TROUBLE SYMPTOM:
LAN communication immobilizer function may not be executed normally.
B: DTC B1101 BATT P/SUPPLY MALFUNCTION
© 2010-2024 Copyright www.suoutback.com
