Subaru Outback (BR): Immobilizer system
This light blinks approximately 60 seconds after the ignition switch is turned from “ON” position to the “Acc” or “LOCK” position or immediately after the key is pulled out. Refer to “Immobilizer” F2-3. If the indicator light does not flash, it may indicate that immobilizer system may be malfunctioning. Contact your nearest SUBARU dealer immediately. In the event that an unauthorized key (for example, an unauthorized duplicate) is used, the security indicator light illuminates.
READ NEXT:
1) Upshift/downshift indicator (AT and CVT models)
This indicator shows the position of the shift lever (MT models) or select lever
(AT and CVT models).
When the manual mode is selected, the gear position indicator (which shows the
current gear selection) and the upshift/ downshift indicator light up. Refer to
“Automatic transmission/Continuousl
The gear position indicator light can be activated or deactivated by performing
the following procedure.
1. Turn the ignition switch to the “LOCK” position.
2. Press the trip knob to show “
SEE MORE:
WARNING
If the Hill Holder indicator light does not illuminate even when the Hill Holder
switch is pressed to activate the Hill Holder function, the electronic parking brake
system may be malfunctioning. Immediately stop the vehicle in a safe location and
contact your SUBARU dealer.
The li
WARNING
● Never adjust the seat while driving to avoid the possibility of loss of vehicle
control and of personal injury.
● Before adjusting the seat, make sure the hands and feet of rear seat passengers
or cargo are clear of the adjusting mechanism.
● After adjusting the se
© 2010-2024 Copyright www.suoutback.com