Subaru Outback (BR): Charge warning light
If this light illuminates when the engine is running, it may indicate that the
charging system is not working properly.
If the light illuminates while driving or does not turn off after the engine
starts, stop the engine at the first safe opportunity and check the alternator belt.
If the belt is loose, broken or if the belt is in good condition but the light remains
illuminated, contact your nearest SUBARU dealer immediately.
READ NEXT:
CAUTION
Do not operate the engine with the oil pressure warning light on. This may cause
serious engine damage.
If this light illuminates when the engine is running, it may indicate that the
e
The engine low oil level warning light illuminates when the ignition switch is
turned to the “ON” position and turns off after approximately 2 seconds.
This light also illuminates when the en
The AT oil temperature warning light “AT OIL TEMP” illuminates when the ignition
switch is turned to the “ON” position and turns off after approximately 2 seconds.
If this light illuminate
SEE MORE:
BJ:DTC P0327 KNOCK SENSOR 1 CIRCUIT LOW (BANK 1 OR SINGLE SENSOR)
1. OUTLINE OF DIAGNOSIS
Detect the open or short circuit of knock sensor.
Judge as NG if out of specification.
2. COMPONENT DESCRIPTION
To knock sensor harness
Case
Weight
Piezoelectric element
Nut
Resistance
3. ENABLE CON
A: REMOVAL
1) Disconnect the ground cable from battery.
2) Remove the rear door trim. <Ref. to EI-61, REAR DOOR, REMOVAL, Door Trim.>
3) Remove the rear door speaker assembly.
Remove the screws.
Disconnect the harness connector and remove the rear speaker assembly.
4) Remove the rear se
© 2010-2024 Copyright www.suoutback.com