Operation

If the driver and/or front passenger have/ has not yet fastened the seatbelt(s) when the ignition switch is turned to the ON position, the seatbelt warning light(s) will flash for 6 seconds, to warn that the seatbelt(s) is/are unfastened. If the drivers seatbelt is not fastened, a chime will also sound simultaneously.

NOTE

● If the drivers and/or front passengers seatbelt(s) are/is still not fastened 6 seconds later, the seatbelt warning device operates as follows according to the vehicle speed.

At speeds lower than approximately 9 mph (15 km/h) The warning light(s) for unfastened seatbelt(s) will alternate between steady illumination and flashing at 15-second intervals. The chime will not sound.

At speeds higher than approximately 9 mph (15 km/h) The warning light(s) for unfastened seatbelt(s) will alternate between flashing and steady illumination at 15-second intervals and the chime will sound while the warning light(s) is/are flashing.

● It is possible to cancel the warning operation that follows the 6-second warning after turning ON the ignition switch. When the ignition switch is turned ON next time, however, the complete sequence of the warning operation resumes. For further details about canceling the warning operation, please contact your SUBARU dealer. If there is no passenger on the front passengers seat, the seatbelt warning device for the front passengers seat will be deactivated. The front passengers occupant detection system monitors whether or not there is a passenger on the front passengers seat.

Observe the following precautions. Failure to do so may prevent the device from functioning correctly or cause the device to fail.

● Do not install any accessory such as a table or TV onto the seatback. . Do not store a heavy load in the seatback pocket.

● Do not allow the rear seat occupant to place his/her hands or legs on the front passengers seatback, or allow him/her to pull the seatback.

● Do not use front seats with their backward- forward position and seatback not being locked into place securely. If any of them are not locked securely, adjust them again. For adjusting procedure, refer to Manual seat F1-3 (models equipped with manual seats only).

passengers seat does not function correctly (e.g., it is activated even when the front passengers seat is empty or it is deactivated even when the front passenger has not fastened his/her seatbelt), take the following actions.

● Ensure that no article is placed on the seat other than a child restraint system and its child occupant.

● Ensure that there is no article left in the seatback pocket.

● Ensure that the backward-forward position and seatback of front passengers seat are locked into place securely by moving the seat back and forth. (Models equipped with manual seats only)

If still the seatbelt warning device for front passengers seat does not function correctly after taking relevant corrective actions described above, immediately contact your SUBARU dealer for an inspection.

    See also:

    Cup holder
    CAUTION ● Do not pick up a cup from the cup holder or put a cup in the holder while you are driving, as this may distract you and lead to an accident. ● Take care to avoid spills. Beve ...

    Parking tips
    When parking your vehicle, always perform the following items. Apply the parking brake firmly. For MT models, put the shift lever in the 1 (1st) for upgrade or R (Reverse) for a downgrade. ...

    Brake assist system
    WARNING Do not be overconfident about the brake assist. It is not a system that brings more braking ability to the vehicle beyond its braking capability. Always use the utmost care when driving r ...