Subaru Outback (BR): Tachometer
The tachometer shows the engine speed in thousands of revolutions per minute.
CAUTION
Do not operate the engine with the pointer of the tachometer in the red zone.
In this range, fuel injection will be cut by the engine control module to protect
the engine from overrevving. The engine will resume running normally after the engine
speed is reduced below the red zone.
NOTE
To protect the engine while the select lever is in the “P” or “N” position (for
AT and CVT models) or the shift lever is in the neutral position (for MT models),
the engine is controlled so that the engine speed may not become too high even if
the accelerator pedal is pressed hard.
READ NEXT:
1) Low fuel warning light
The fuel gauge shows the approximate amount of fuel remaining in the tank. When
the ignition switch is in the “LOCK” or “Acc” position, the fuel gauge shows “E
The fuel tank's low fuel warning light activates when it's nearly empty and only functions with the ignition switch in the "ON" position. When this light comes on, it's crucial to refill the
1) U.S.-spec. models
2) Except U.S.-spec. models
The ECO gauge shows the difference between the average rate of fuel consumption
and the current rate of fuel consumption. Using the average rate
SEE MORE:
A: REMOVAL
1. SEDAN MODEL
1) Disconnect the ground cable from battery and wait for at least 60 seconds
before starting work.
CAUTION:
The airbag system is fitted with a backup power supply. After disconnecting the
battery ground cable,
the airbag may operate if you do not wait for 60 seconds befor
The gear position indicator light can be activated or deactivated by performing
the following procedure.
1. Turn the ignition switch to the “LOCK” position.
2. Press the trip knob to show “ ” or “ ” on the trip meter display.
The display can be switched as shown in the following ill
© 2010-2024 Copyright www.suoutback.com