Subaru Outback (BR): Double trip meter
1) Trip knob
This meter displays the two trip meters when the ignition switch is in the “ON” position.
The trip meter shows the distance that the vehicle has been driven since you last set it to zero.
If you press the trip knob when the ignition switch is in the “LOCK” or “Acc” position, the odometer/trip meter will light up. It is possible to switch between the A trip meter and B trip meter indications while the odometer/trip meter is lit up. If you do not press the trip knob within 10 seconds of illumination of the odometer/trip meter, the odometer/trip meter will turn off. Also, if you open and close the driver’s door within 10 seconds of illumination of the odometer/trip meter, the odometer/trip meter will turn off.
The display can be switched as shown in the following illustration by pressing the trip knob.
To set the trip meter to zero, select the A trip or B trip meter by pressing the knob and keep the knob pressed for more than 2 seconds.
CAUTION
To ensure safety, do not attempt to change the function of the indicator during driving, as an accident could result.
NOTE
If the connection between the combination meter and battery is broken for any reason such as vehicle maintenance or fuse replacement, the data recorded on the trip meter will be lost.
READ NEXT:
Tachometer
The tachometer shows the engine speed in thousands of revolutions per minute.
CAUTION
Do not operate the engine with the pointer of the tachometer in the red zone.
In this range, fuel injection wi
Fuel gauge
1) Low fuel warning light
The fuel gauge shows the approximate amount of fuel remaining in the tank. When
the ignition switch is in the “LOCK” or “Acc” position, the fuel gauge shows “E
If the Low fuel warning light lights up
The fuel tank's low fuel warning light activates when it's nearly empty and only functions with the ignition switch in the "ON" position. When this light comes on, it's crucial to refill the
SEE MORE:
MT Gear Select Cable
A: REMOVAL
CAUTION:
Always use new MT gear select cable if the cable is removed from selector lever
COMPL of transmission
side.
1) Disconnect the ground cable from battery.
2) Remove the ten clips and remove the grille bracket.
3) Remove the air intake duct.
Non-turbo model
<Ref. to IN(H4S
DTC P0107, P0108, P0111, P0112, P0113, P0117, P0118, P0122, P0123, P0125,
P0126, P0128
P: DTC P0107 MANIFOLD ABSOLUTE PRESSURE/BAROMETRIC PRESSURE
CIRCUIT LOW INPUT
1. OUTLINE OF DIAGNOSIS
Detect the open or short circuit of intake manifold pressure sensor.
Judge as NG if out of specification.
2. COMPONENT DESCRIPTION
Output voltage
Absolute pressure
Connector
Terminals
O-
