Subaru Outback (BR): Tripped sensor identification
Subaru Outback (BR) 2010-2015 Owners Manual / Keys and doors / Alarm system / Tripped sensor identification
The security indicator light flashes when the alarm system has been triggered. Also, the number of flashes indicates the location of unauthorized intrusion or the severity of impact on the vehicle.
When the ignition switch is turned to the “ON” position, the indicator light will illuminate for 1 second and then flash as follows:
● When a door or rear gate (Outback) was opened: 5 times ● When the trunk (Legacy) was opened: 4 times ● When a strong impact or multiple impacts were sensed: twice (only models with shock sensors (dealer option)) ● When a light impact was sensed: once (only models with shock sensors (dealer option))
READ NEXT:
Shock sensors (dealer option)
The shock sensors trigger the alarm system when they sense impacts applied to
the vehicle and when any of their electric wires is cut. The alarm system causes
the horn to sound and the turn signal
Child safety locks
WARNING
Always turn the child safety locks to the “LOCK” position when children sit on
the rear seat. Serious injury could result if a child accidentally opens the door
and falls out.
Each
Windows
WARNING
To avoid serious personal injury caused by entrapment, always conform to the
following instructions without exception.
● When operating the power windows, be extremely careful to pre
SEE MORE:
Examples of the types of accidents in which the SRS side airbag and SRS curtain
airbag will basically not deploy.
1) The vehicle is involved in frontal collision with another vehicle (moving
or stationary).
2) The vehicle is struck from behind.
3) The vehicle pitches end over end.
In the event of accidents like those illustrated, the SRS side airbag and SRS
curtain airbag are basically not designed to
Cooling or dehumidifying
For cooling and dehumidification of the passenger compartment, air flows through
the instrument panel outlets:
1. Set the air inlet selection button to the OFF position.
2. Press the “” button.
3. Set the air conditioner button to the “ON” position.
4. Set the temperature control dial
© 2010-2024 Copyright www.suoutback.com
