Subaru Outback (BR): Disarming the system
Briefly press the “” button (for
less than 2 seconds) on the remote transmitter. The driver’s door will unlock, an
electronic chirp will sound twice, the turn signal lights will flash twice and the
security indicator light will turn off.
To unlock all other doors and the rear gate (Outback), briefly press the “”
button a second time within 5 seconds.
READ NEXT:
If you cannot disarm the system using the transmitter (i.e. the transmitter is
lost, broken or the transmitter battery is too weak), you can disarm the system
without using the transmitter.
The s
When you choose the valet mode, the alarm system does not operate. In valet mode,
the remote transmitter is used only for locking and unlocking the doors and rear
gate (Outback) and panic activati
When passive arming mode has been programmed by the dealer, arming of the system
is automatically accomplished without using the remote transmitter. Note that in
this mode, DOORS MUST BE MANUALLY
SEE MORE:
This light illuminates when the brake fluid level has dropped
to near the “MIN” level of the brake fluid reservoir with the ignition switch in
the “ON” position and with the parking brake released.
If the brake system warning light should illuminate while driving
(with the parking bra
A: PROCEDURE
CAUTION: Remove foreign matter (dust, water, oil etc.) from the VDCCM&H/U connector during removal and installation.
NOTE:
To check the harness for open or short circuits, shake problem spot or connector.
Refer to "Check List for Interview". <Ref. to VD
© 2010-2024 Copyright www.suoutback.com