Remote keyless entry system

CAUTION

● Do not expose the remote transmitter to severe shocks, such as those experienced as a result of dropping or throwing.

● Do not take the remote transmitter apart except when replacing the battery.

● Do not get the remote transmitter wet. If it gets wet, wipe it dry with a cloth immediately.

● When you carry the remote transmitter on an airplane, do not press the button of the remote transmitter while in the airplane. When any button of the remote transmitter is pressed, radio waves are sent and may affect the operation of the airplane. When you carry the remote transmitter in a bag on an airplane, take measures to prevent the buttons of the remote transmitter from being pressed.

● FCC WARNING Changes or modifications not expressly approved by the party responsible for compliance could void the users authority to operate the equipment.

This device complies with Part 15 of the FCC Rules and RSS-Gen of IC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

The transmitter for the remote keyless entry system is located inside the key head.

The remote keyless entry system has the following functions.

● Locking and unlocking the doors (and rear gate (Outback)) without a key ● Opening the trunk lid (Legacy) without key ● Sounding a panic alarm ● Arming and disarming the alarm system. For detailed information, refer to Alarm system F2-15.

The operable distance of the remote keyless entry system is approximately 30 feet (10 meters). However, this distance will vary depending on environmental conditions. The systems operable distance will be shorter in areas near a facility or electronic equipment emitting strong radio waves such as a power plant, broadcast station, TV tower, or remote controller of home electronic appliances.

NOTE

The remote keyless entry system does not operate when the key is inserted in the ignition switch.


Locking the doors


See also:

ABS warning light
If any of the following conditions occur, we recommend that you have the ABS system repaired at the first available opportunity by your SUBARU dealer. The warning light does not illuminate ...

All-Wheel Drive warning light (AT models)
This light illuminates when All-Wheel Drive is disengaged and the drive mechanism is switched to Front Wheel Drive for maintenance or similar purposes. It flashes if the vehicle is driven w ...

Low tire pressure warning light (U.S.-spec. models)
When the ignition switch is turned to the ON position, the low tire pressure warning light will illuminate for approximately 2 seconds to check that the tire pressure monitoring system (TPMS) ...