Subaru Outback (BR): Security indicator light
The security indicator light deters potential thieves by indicating that the
vehicle is equipped with an immobilizer system. It begins flashing approximately
60 seconds after the ignition switch is turned from the “ON” position to the “Acc”
or “LOCK” position or immediately after the key is pulled out.
If the security indicator light does not flash, the immobilizer system may be
malfunctioning. If this occurs, contact your SUBARU dealer as soon as possible.
In case an unauthorized key is used (e.g. an imitation key), the security indicator
light illuminates.
NOTE
Even if the security indicator light flashes irregularly or its fuse blows (the
light does not flash if its fuse is blown), the immobilizer system will function
normally.
READ NEXT:
Your key number plate and security ID plate will be required if you ever need
a replacement key made. Any new key must be registered for use with your vehicle’s
immobilizer system before it can
To lock the driver’s door from the outside with the key, turn the key toward
the rear. To unlock the door, turn the key toward the front.
Pull the outside door handle to open an unlocked door.
SEE MORE:
BA:DTC P0202 INJECTOR #2
NOTE:
For the diagnostic procedure, refer to DTC P0201. <Ref. to EN(H4SO)(diag)-162,
DTC P0201 INJECTOR
#1, Diagnostic Procedure with Diagnostic Trouble Code (DTC).>
BB:DTC P0203 INJECTOR #3
NOTE:
For the diagnostic procedure, refer to DTC P0201. <Ref. to EN(H4SO)(
CAUTION
Do not use sharp instruments or window cleaner containing abrasives to clean
the inner surface of the window on which the antenna is printed. Doing so may damage
the antenna printed on the window.
The antenna is printed on the inner surface of the rear window glass.
NOTE
Antenna pe
© 2010-2024 Copyright www.suoutback.com