Subaru Outback (BR): To hook the top tether
CAUTION
Always remove the head restraint when mounting a child restraint system with
a top tether. Failure to do so may prevent the top tether from being fastened tightly.
Outback
1. Remove the head restraint at the seating position where the child restraint
system has been installed with the seatbelt or lower anchorages; lift up the head
restraint while pressing the release button. Store the head restraint in the cargo
area. Avoid placing the head restraint in the passenger compartment to prevent it
from being thrown around in the passenger compartment in a sudden stop or a sharp
turn.
2. Open the cover flaps to use the anchorages.
3. Fasten the top tether hook of the child restraint system to the appropriate
upper anchorage.
4. Tighten the top tether securely.
READ NEXT:
*SRS: This stands for supplemental restraint system. This name is used because
the airbag system supplements the vehicle’s seatbelts.
Your vehicle is equipped with a crash sensing and diagnostic
Your vehicle is equipped with a supplemental restraint system in addition to
a lap/shoulder belt at each front seating position and each rear window-side seating
position. The supplemental restrai
1) Front sub sensor (right-hand side)
2) Front sub sensor (left-hand side)
3) SRS airbag system warning light
4) Frontal airbag module (driver’s side)
5) Front passenger’s frontal airbag O
SEE MORE:
● Accessory weight
The combined weight (in excess of those standard items which may be replaced)
of automatic transmission, power steering, power brakes, power windows, power seats,
radio, and heater, to the extent that these items are available as factory-installed
equipment (whether i
A: REMOVAL
CAUTION:
Always use new MT gear select cable if the cable is removed from selector lever
COMPL of transmission
side.
1) Disconnect the ground cable from battery.
2) Remove the ten clips and remove the grille bracket.
3) Remove the air intake duct.
Non-turbo model
<Ref. to IN(H4S
© 2010-2024 Copyright www.suoutback.com