Subaru Outback manuals

Subaru Outback (BR): Installing a booster seat

WARNING

● Child restraint systems and seatbelts can become hot in a vehicle that has been closed up in sunny weather; they could burn a small child. Check the child restraint system before you place a child in it.

● Do not leave an unsecured child restraint system in your vehicle. Unsecured child restraint systems can be thrown around inside of the vehicle in a sudden stop, turn or accident; they can strike and injure vehicle occupants as well as result in serious injuries or death to the child.

CAUTION

When you install a child restraint system, follow the manufacturer’s instructions supplied with it. After installing the child restraint system, check to ensure that it is held securely in position. If it is not held tight and secure, the danger of your child suffering personal injury in the event of an accident may be increased.

1. Place the booster seat in the rear seating position and sit the child on it.


1. Place the booster seat in the rear seating position and sit the child on it. The child should sit well back on the booster seat.

2. Run the lap and shoulder belt through or around the booster seat and the child following the instructions provided by its manufacturer.

3. Insert the tongue plate into the buckle until you hear a click. Take care not to twist the seatbelt.

Make sure the shoulder belt is positioned across the center of child’s shoulder and that the lap belt is positioned as low as possible on the child’s hips.

4. To remove the booster seat, press the release button on the seatbelt buckle


4. To remove the booster seat, press the release button on the seatbelt buckle and allow the belt to retract.

WARNING

● Never use a belt that is twisted or reversed. In an accident, this can increase the risk or severity of injury to the child.

● Never place the shoulder belt under the child’s arm or behind the child’s back. If an accident occurs, this can increase the risk or severity of injury to the child.

● The seatbelt should fit snugly in order to provide full restraint. Loose fitting belts are not as effective in preventing or reducing injury.

● Place the lap belt as low as possible on the child’s hips. A high-positioned lap belt will increase the risk of sliding under the lap belt and of the lap belt sliding up over the abdomen, and both can result in serious internal injury or death.

● Make sure the shoulder belt is positioned across the center of child’s shoulder. Placing the shoulder belt over the neck may result in neck injury during sudden braking or in a collision.

READ NEXT:

 Installation of child restraint systems by use of lower and tether anchorages (LATCH)

WARNING ● Child restraint systems and seatbelts can become hot in a vehicle that has been closed up in sunny weather; they could burn a small child. Check the child restraint system before

 Top tether anchorages

Your vehicle is equipped with three top tether anchorages so that a child restraint system having a top tether can be installed in the rear seat. When installing a child restraint system using top

 Tether anchorage location

Outback Three tether anchorages, i.e., ones for the right, center and left positions, are already installed on the rear edge of the roof. Open the cover flap to use each anchorage.

SEE MORE:

 Aluminum wheels

Aluminum wheels can be scratched and damaged easily. Handle them carefully to maintain their appearance, performance, and safety. ● When any of the wheels is removed and replaced for tire rotation or to change a flat, always check the tightness of the wheel nuts after driving approximatel

 General Description of Vehicle Dynamics Control

A: SPECIFICATION B: COMPONENT 1. ABS WHEEL SPEED SENSOR Front ABS wheel speed sensor Front axle housing Rear ABS wheel speed sensor Rear axle housing Hub unit bearing Magnetic encoder Tightening torque:N*m (kgf-m, ft-lb) T: 7.5 (0.76, 5.5) 2. STEERING ANGLE

© 2010-2024 Copyright www.suoutback.com