Subaru Outback: System servicing
WARNING
● When discarding a seatbelt retractor assembly or scrapping the entire vehicle
damaged by a collision, consult your SUBARU dealer.
● Tampering with or disconnecting the system’s wiring could result in accidental
activation of the seatbelt pretensioner and/or airbag or could make the system inoperative,
which may result in serious injury. Do not use electrical test equipment on any
circuit related to the seatbelt pretensioner and airbag systems. For required servicing
of the seatbelt pretensioner, consult your nearest SUBARU dealer.
CAUTION
The front sub sensors are located in both front fenders and the airbag control
module including the impact sensors is located under the center console. If you
need service or repair in those areas or near the front seatbelt retractors, have
the work performed by your authorized SUBARU dealer.
NOTE
If the front part of the vehicle is damaged in an accident to the extent that
the seatbelt pretensioner does not operate, contact your SUBARU dealer as soon as
possible.
READ NEXT:
Always consult your SUBARU dealer if you want to install any accessory parts
to your vehicle.
CAUTION
Do not perform any of the following modifications. Such modifications can interfere
with pro
Infants and small children should always be placed in an infant or child restraint
system in the rear seat while riding in the vehicle.
You should use an infant or child restraint system that mee
The following descriptions are SUBARU’s recommendations on where to place a child
restraint system in your vehicle.
A: Front passenger’s seat
You should not install a child restraint system
SEE MORE:
The following suggestions will help to save your fuel.
● Select the proper gear position for the speed and road conditions.
● Avoid sudden acceleration or deceleration. Always accelerate gently until you
reach the desired speed. Then try to maintain that speed for as long as possible
1. Remove the glove box.
(1) Open the glove box.
(2) Remove the damper shaft from the glove box.
(3) Pull out the glove box.
2. Remove the cover of the air filter.
3. Remove the air filter.
4. Replace the air filter element with a new one.
5. Reinstall the cover of the air filter.
© 2010-2024 Copyright www.suoutback.com