Subaru Outback: Door step light
1. Remove the lens by prying the edge of the lens with a flat-head screwdriver.
2. Pull the bulb out of the socket.
3. Install a new bulb.
4. Reinstall the lens.
READ NEXT:
1. Remove the lens by prying the edge of the lens with a flat-head screwdriver.
2. Pull the bulb out of the socket.
3. Install a new bulb.
4. Reinstall the lens.
Other bulbs may be difficult to replace. We recommend that you have the bulbs
replaced by your SUBARU dealer if necessary.
SEE MORE:
Check the engine oil level at each fuel stop.
1. Park the vehicle on a level surface and stop the engine. If you check the
oil level just after stopping the engine, wait a few minutes for the oil to drain
back into the oil pan before checking the level.
2. Pull out the level gauge, wipe it c
The light illuminates when the ignition switch is turned to the “ON” position
and turns off after approximately 2 seconds. The light illuminates when the Vehicle
Dynamics Control OFF switch is pressed to deactivate the Vehicle Dynamics Control
system.
The following two situations could
© 2010-2024 Copyright www.suoutback.com